Skip to main content Go to search Go to main navigation
Item no. Colour Price SP Delivery time Quantity
2001.0111.0011
CHF 18.50
for Piece

1–2 days

2001.0111.0013
CHF 22.15
for Piece

1–2 days

2001.0111.0012
CHF 20.30
for Piece

1–2 days

No results found

Order the cut-to-size piece according to your specifications.

Frequently Asked Questions (FAQ)

Measure the width of your joint and choose the tape that falls within the range of this measurement. For example, for a 10 mm joint, the BSB BG1 15/7-12 is suitable. If your measurement falls exactly on the boundary between two sizes, choose the size where it is closer to the middle of the range. Also check whether your joint is deep enough.
The 15 refers to the width of the tape in millimetres. 7–12 means that the tape reliably seals joints between 7 and 12 mm wide.
For fire protection, the joint should be at least one and a half times as deep as it is wide. The manufacturer recommends a joint depth of at least 15 mm for the 15/5-9, at least 20 mm for the 15/7-12 and at least 25 mm for the 20/8-15.
When installed in a single layer, the tape achieves up to EI 20. When installed in two layers, it achieves up to EI 60 between masonry and timber frames and up to EI 120 between masonry. The joint configuration, as described in the test report, is always decisive. We would be happy to send you the test report.
That depends on the building. Before installation, please check with the quality assurance manager responsible for fire safety or the fire safety authority to clarify what fire resistance is required and whether the test report is sufficient for this purpose. We will be happy to assist you with the necessary documentation.
Divide the total tape length by the length per roll and round up. For double-layer installation, you will need twice the length. For a 12-metre joint, double-layered, using BSB BG1 15/7-12 (4.3 metres per roll), this amounts to 24 metres and, mathematically, six rolls; we recommend seven.
Peel off the protective paper, stick the tape onto one side of the joint without stretching it, and position it approximately 2 to 10 mm behind the front edge. Always lay the tape so that it is wider than it is high, and ensure the joints are seamless. It will then expand on its own. Detailed installation instructions can be found in the downloads section.
Between +5 °C and +45 °C. In cold conditions, the tape expands much more slowly. Make sure to reseal any opened rolls immediately, otherwise the tape will start to expand whilst still on the roll.
Yes. The tape meets the BG1 exposure class requirements and is therefore also suitable for joints directly exposed to the elements.
When stored in a dry place in its original packaging, 18 months from the date of manufacture.
Yes. The tape has been tested as flame-retardant (B1) and in accordance with DIN 18542 (BG1), and its fire resistance has been verified in accordance with EN 1366-4. We will be happy to send you the test certificates and test report on request.