Skip to main content Go to search Go to main navigation
Item no. Colour Price SP Delivery time Quantity
2001.0111.0014
CHF 12.75
for Piece

1–2 days

2001.0111.0015
CHF 9.40
for Piece

1–2 days

2001.0111.0016
CHF 26.60
for Piece

1–2 days

No results found

Order the cut-to-size piece according to your specifications.

Frequently Asked Questions (FAQ)

That depends on what the tape needs to achieve. For stress group BG2, the HBD 15/2-5 is suitable for joints up to 4 mm, the 15/3-9 for up to 7 mm and the 40/5-12 for up to 10 mm. When used purely as thermal insulation tape, the same tapes are suitable for joints up to 13, 24 and 32 mm respectively. You can find the exact values in the data sheet.
The 15 refers to the width of the tape in millimetres; the joint must therefore be at least 15 mm deep. 3-9 means: for joint widths between 3 and 9 mm, the tape is resistant to driving rain up to 300 Pa. For more stringent requirements, the range is narrower; for thermal insulation, it is wider.
HBD meets the BG2 service class and is intended for concealed installation. BG1 meets the highest service class, BG1, and may be installed in areas exposed to the elements.
Yes, provided the joint is covered, for example by cladding, a cover strip or façade cladding. For visible joints directly exposed to the elements, use Hannoband®-BG1.
Divide the total joint length by the roll length and round up. Allow a little extra for corners and joints. For a 12-metre joint and the HBD 15/3-9, which is 6 metres per roll, the calculation suggests two rolls; we recommend three.
Peel off the protective paper, stick the tape onto one side of the joint without stretching it, and position it approximately 2 to 10 mm behind the front edge. Always apply the tape so that it is wider than it is high. It will then open up by itself. Detailed installation instructions can be found in the downloads section.
This depends on the temperature: it happens faster in warm conditions and significantly slower in cold conditions. Make sure to reseal any opened rolls immediately, otherwise the tape will start to open up whilst still on the roll.
Yes. With a thermal conductivity of 0.0396 W/(m·K), the tape insulates the joint and can cover wider joints than is required for resistance to driving rain.
When stored in a dry place in its original packaging, 24 months from the date of manufacture.
Yes. The tape has been tested in accordance with DIN 18542 (BG2), is subject to third-party monitoring and has very low emissions in accordance with EMICODE® EC1PLUS. We will be happy to send you the test certificates on request.