Skip to main content Go to search Go to main navigation
Item no. Colour Price SP Delivery time Quantity
2001.0111.0005
CHF 19.30
for Piece

1–2 days

2001.0111.0006
CHF 18.60
for Piece

1–2 days

2001.0111.0007
CHF 22.05
for Piece

1–2 days

2001.0111.0008
CHF 55.15
for Piece

1–2 days

2001.0111.0009
CHF 70.60
for Piece

1–2 days

2001.0111.0010
CHF 127.55
for Piece

1–2 days

No results found

Order the cut-to-size piece according to your specifications.

Frequently Asked Questions (FAQ)

Measure the width of your joint and choose the tape that falls within the range for that measurement. For example, for a joint of 10 mm, the BG1 20/8-15 is suitable. If your measurement falls exactly on the boundary between two sizes, choose the size where it is closer to the middle of the range.
The 20 refers to the width of the tape in millimetres; the joint must therefore be at least 20 mm deep. 8–15 means that the tape reliably seals joints between 8 and 15 mm wide.
The BG1-M has an additional membrane inside and is designed for wide joints measuring between 8 and 35 mm. The standard BG1 is sufficient for narrow joints.
Divide the total joint length by the roll length and round up. Allow a little extra for corners and joints. For a 12-metre joint and the BG1 20/8-15, which is 3 metres per roll, the calculation gives four rolls; we recommend five.
Peel off the protective paper, stick the tape onto one side of the joint without stretching it, and position it approximately 2 to 10 mm behind the front edge. Always apply the tape so that it is wider than it is high. It will then open up by itself. Detailed installation instructions can be found in the downloads section.
This depends on the temperature: it happens faster in warm conditions and significantly slower in cold conditions. Make sure to reseal any opened rolls immediately, otherwise the tape will start to open up whilst still on the roll.
Yes. The tape is designed for use on the weather-exposed exterior, but thanks to its good sound insulation properties, it also seals connection joints in interior fit-out work.
When stored in a dry place in its original packaging, 24 months from the date of manufacture.
Yes. The tape has been tested in accordance with DIN 18542 (BG1) and as flame-retardant (B1), and bears the CE mark. We will be happy to send you test certificates and a declaration of performance on request.